Installing Metal Roof With Elevated Section

Dan lane vice president installation manager american metal.

Installing metal roof with elevated section.

Next you are ready to install the metal roof. Metal roofing 101 diy steel roofing installation over shingles subscribe. When installing a metal roof people usually installed over battens rather than solid wood surfaces or use wrong fasteners or do not overlap the panels adequately. Covering the entire low slope section with a water and ice shield is the best way to ensure that the roof does not leak.

You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened. Installing low slope metal roofing attain high marks for low slope roof installation. You can use 1 inch nails for the installation of eave flashing. Email protected follow us on.

Before you install metal roofing repair any damage to the wood under the shingles. Use 1 1 4 inch nails to cover the outline of the roof with strips of metal eave flashing also called edging. Place corner pieces where panels will meet bends at the edge of the roofing. Next use 1 inch nails to secure some metal edging to the perimeter of the roof.

If there are gutters installed on the eaves the eave flashing should be installed to overhang the lip of the gutter by about 1 2 inch. Read the list of common mistakes that you can avoid while installing a metal roof. Changes to a steeper roof below such as between sections h and i. Then cover the entire roof with a layer of insulation and secure it with a staple gun.

For successful low slope metal roof installation mark graham.