Installing Vinyl Board And Batten Siding Around Windows

If your sheathing is not solid plywood or osb these strips are needed to provide a nailing surface.

Installing vinyl board and batten siding around windows.

It s finally time to install the vinyl siding on the garage. Isolate panel style board and batten vinyl siding walls with extruded polystyrene xps rigid foam usually 1 1 2 inches thick. If you are installing j channel around replacement windows that do not have nail flanges flash the window before you trim it. Use uncoated xps with fiberglass bats that have a vapor before installing inside the wall.

Then you can hang the j channel to hold the siding in place at the top and bottom of the wall and also around all windows and doorways. Attach strips around windows and doors then lay out and attach horizontal strips every 16 inches. To establish the vertical starting base use a chalk line and a level to obtain a. Line up the panel with the edging and use screws to secure it in place on the nailing strip.

Also for best results use aviation snips when cutting the j channel. Nail the strips to framing members. There are so many how to install vinyl siding videos out there i didn t see the point in maki. Like many types of siding you ll start installing the board and batten panels from one side.

5 key points for installing board batten vertical vinyl siding 1. In some areas it is common to attach vertical 1x2 furring strips before installing board and batten siding. Make sure to check your local building codes to ensure you allow enough space between the bottom channel and the ground. This is meant to give you.

This will maintain enough room for vertical expansion and contraction and ease of installation. Installing window and door trim to trim windows and doors install j channel along the top and sides of the door casings and around windows. The next panel will fit over the edge of the previous one disguising the nailing strip and lock securely into place. Nail 4 by 8 foot panels to wall studs with a hammer and 3 inch galvanized nail to penetrate a half inch in the studs.

Installing around windows doors cut outs when measuring board batten panels to be cut and installed around windows doors and other cut outs it is important to leave 1 4 gap on the top bottom and sides.