Installing a new roof over shingles takes less time than tearing off the old roof.
Installing roof shingles over old shingles.
Is it okay to put the new shingles right over the old ones.
To start installing shingles line up aluminum drip edge flush with the edge of the roof and make a pencil line at the.
Has the same manufacturer s warranty.
The first row of shingles should overhang the drip edge of the roof.
If conditions are right new shingles laid over old shingles can be just as attractive and durable as shingles laid on bare sheathing.
Pull the drip edge down about a half inch from that line to.
Do both sides first and then install ridge cap shingles over the top.
That s also why building codes commonly limit re roofing to no more than two layers.
You want to be sure that you will be installing the shingles over only one other layer though.
Done correctly a reroof job will look as good and last as long as a new roof for a lot less money and a lot less hassle.
But you must take care to install shingles correctly so they lie flat.
But unless the sheathing is extensively damaged or the structure can t support the weight of another layer of roofing a better solution is to apply a new layer of shingles right over the old one.
Finally i had time to put the video clips together.
Use 1 5 or 1 75 inch roofing nails.
Looks just as good and lasts as long.
As long as it s done right and under the right conditions installing new shingles over old ones can last as long and look just as good as a complete re roof.
If you are looking to save time installing new shingles over old shingles is a possible roof replacement solution.
Installing new roof shingles over old effectively doubles the weight of the roofing so you have to make sure your roof structure can handle the extra load.
If you need to redo your roof you might be tempted to save some money by having another layer installed over the existing shingles.
Installing roof shingles in 11 steps.
The third layer of shingles will be too heavy to be supported.
Please click show more below to know.
Each shingle will require around 4 nails underneath the tar line and about half an inch under where the next shingle will overlap.
Installation is easier than for a tear off job because you can use the existing shingles as guides for laying the new ones.
Place the top of each starter shingle firmly against the bottom of the shingle immediately above it and even with the eaves then nail it into place.
Around an inch should do.