Slide the splices on as far as they ll go.
Installing gutter pops.
Hook one side of the chalk line to the nail at the start of the gutter run.
Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
It s much easier to join sections on the ground than to work from the top of a ladder.
Snap a chalk line between the start and end of the gutter run.
Use a square and pencil to mark the gutter length and cut to the line.
Here are the steps to installing a pop up gutter drain system.
Wrap the aluminum strip tight around the underside of the gutter.
These drains are attached to the end of a pipe that runs underneath the surface of your yard.
Firmly hit the top of the nails with a hammer to drive them into each point.
Snap the sections together.
Locate the endpoints and hold a nail over each.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
We provide a fully licensed plumber to do all your gutter.
How to install a pop up gutter drain.
Secure it with eight pop rivets or sheet metal screws.
Begin by installing a slip joint splice on each end of an inside corner fitting.
Cut a triangular section from.