Designer custom door or drawer panel installation.
How to install panel door on sub zero fridge.
Assembly from door see figure 2.
Signals a situation.
To install the handle reverse the above steps.
10 reinstall panel assemblies and replace door trim.
To install the custom door panel partially insert a screw in the center of each mounting position on the hinge side of the door.
Engage the tabbed bracket to the handle side of the door then slide the hinge side mounting bracket onto positioning screws.
Overlay panels must be a minimum of 5 8 thick to support mounting the handle.
Install custom panels on a designer formerly integrated product.
Pull the trim strip down to pull it out from under the top trim.
9 if there is flex in the center of the panel install short pieces of leftover cleat stock to the back of the panel to maintain spacing from the unit door.
Slide door panel into door trim frame see figure 2.
700 series panel removal.
See also sub zero standard and accessory handle information.
If panel is less than 1 4 6 mm thick install chipboard filler panels behind panel.
Framed handle is loose.
States a hazard that may cause serious injury or death if precautions are not followed.
With panel in position secure handle assembly to door by reinstalling handle mounting screws see figure 2.
Loose handle on sub zero custom panel.
How to mount or remove panels from designer series doors and drawers.
Sub zero stainless steel door handles are typically mounted 1 1 2 from the handle side of the door or top of the drawer.
Signals a situation where minor injury or product damage may occur if you do not follow instructions.
Refer to the product installation guide for further installation information.
Grasp the trim on one side of the door near the bottom and pull the trim away from the refrigerator.
Panel mounting brackets for designer units.
See also framed door panel installation instructions.
Slotted holes on the mounting bracket should slide under screw heads to support the panel.
Make sure the built in unit is secured in place with anti tip brackets to prevent tipover when panel weight is added to open doors.