How To Install Garage Door Emergency Key Release

Pull the emergency release cord toward the door.

How to install garage door emergency key release.

Garagedoorlock quickreleaselock in this video dave is going to show us how to do that garage door quick release lock installation. This allows you to disconnect the garage door opener from the door. To test your door walk over to it and try to lift it up. Tie a single overhand knot in the cord about an inch from the end.

When the key is turned the body of the lock can be pulled through the door bringing the cable with it. 3 feed the other end of the cord through the emergency release lever on the door opener. Pull the end through until the handle is. The lock mechanism is installed into a hole on the garage door.

If it is a smooth test close the garage door and reset the emergency release cord by simply plugging it back in. Now you know how to use your garage door s emergency release. Attach the emergency key release to the door and connect the end of the cable to the trolley where the emergency release rope is attached. In relation to the emergency release cord the trolley has two positions.

Open and close it a few times noting any irregularities with functionality. You drill a hole through the door large enough for the barrel of the emergency key release to install in it. A garage door with weak or broken springs may cause it to slam. Once you are done maneuvering your garage door and are ready to re engage the automatic door opener please return the garage door back to the down position.

The cable is unrolled and attached to the emergency release lever on the garage door opener s trolley. Once closed reach up and pull the cord down disengaging the carriage from the trolley. This is needed for gara.