You may need to use a putty knife to break the seam between the first course and the starter strip.
How to install drip edge flashing on a flat roof.
Please like and subscribe for more instructional videos.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
Lift the shingles slide the drip edge underneath them and position it so that it extends over the gutters then replace the shingles and push down to seat the drip edge.
Use a flat pry bar to remove drip edge nails along the eave and rakes.
Coat the flat part of the flashing that sits on the deck using a putty knife.
Secure the drip edge with roofing cement.
Install roof drip edge along the eaves add underlayment then place drip edge along the gable end.
If using a type c drip edge you can install a furring strip to increase its performance.
Apply roofing cement when installing drip edge on an existing roof.
The best way is to install the roof drip edge only along the eaves first then place ice and water barrier in the snowbelt or felt paper underlayment over the drip edge.
How to install a drip edge.
Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto the roof.
Make sure the outer edge extends over the gutter.
At 7 05 paul begins replacing the drip edge roof flashing.
Use a flat pry bar and hammer to pry the nails out of the drip edge gently.
If it doesn t pull the drip edge out slightly from under the shingles.