How To Install A Bath Fan Roof Vent

From the roof find the nail and use the utility knife to cut roof shingles from around the nail.

How to install a bath fan roof vent.

Use an extra long 3 8 inch diameter spade bit to bore a reference hole through the ceiling and into the attic. The 2nd bathroom vent drips on the floor and is ruining the ceiling. Here is the link to th. We explain how to install bathroom exhaust fans or vents the vent ducting the vent termination at the wall soffit or roof vent fan wiring bath vent duct insulation bath vent lengths clearances routing and we answer just about any other bathroom ventilation design or installation question you may have.

Depending on the location of the bathroom it may be easy to vent the exhaust fan through the roof. Use rigid metal ducting aluminum or galvanized steel with lengthwise seams facing up and joints sealed with foil tape or duct mastic or rigid plastic pipe. Draw a mark on the bathroom ceiling where you d like to install the vent fan. From inside the attic drive a nail through the roof directly above the bathroom vent fan.

Nail the lower corners with roofing nails and tar the heads. Secure the vent flanges with roofing nails before installing the shingles. Apply a bead of asphalt roof cement on the bottom of the vent. For optimum performance locate it between the shower and the toilet.

This involves running ductwork from the fan usually though an attic and out through the roof. It is because of this that many builders tend to advise against this method. Install the roof vent by sliding the top flange under the shingles above it and resting the bottom flange on the shingles below. The master bathroom and the 2nd bathroom vent through the roof and through the same opening.

If you vent through a soffit where attic vents are often located the moisture will get sucked back up into the attic or roof venting. Apply roofing adhesive on the underside of the flanges to seal. The lower half of the flange sits on top of the shingles. Slide the vent under the shingles so they cover the top half of the vent flange.

The 2 pipes one a 4 master and the other a 3 2nd do not go through the ceiling but into a common box that goes through the roof. In order to accomplish this the roof has to have a hole cut in it.