Some older plaster walls have a thin strip of wood that runs around the perimeter of a room usually between 1 inch 2 5 cm to 1 foot 30 cm below the edge of the ceiling.
How to hang wall art on plaster walls.
Wood lath plaster walls that are commonly foun.
It also prevents mildew that can form in the porous plaster.
Drill a hole the same diameter of the plastic plaster anchor insert if you are hanging in area without a wall stud.
Use a picture rail if you have one.
If the mount is straight the bubble in the liquid will stay in the center.
How to hang on plaster walls with a picture hanging system the ideal solution for hanging pictures on plaster is to use a picture hanging system like the all in one click rail cable hanging kit.
Learn a very simple drill free way to hang pictures and other things on hard plaster sheet walls with ease.
Perform the cleaning using warm water and a mild liquid dish soap.
This system works by simply installing a rail along the wall and pictures then hang from cables attached to the rail and are fastened with hooks.
Use a carpenter s level to level the mount on the wall.
Take care not to overtighten.
Seat the round flange flush with the wall surface by tapping the screwhead.
For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done.
How to hang lightweight pictures on plaster walls.
Next drill a hole into the mark using a 3 16 drill bit before removing the piece of tape.
You ll know this is happening if the anchor flange starts to depress the surface of the plaster or drywall.
Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail.
Then hammer a wall anchor into the hole until it s flush with the plaster.
To hang a picture on a plaster wall make a pencil mark where you want to hang the picture then cover the mark with a small piece of painter s tape.
Press the mount flat against the wall then set the level on top of it.
If your room has this you can simply drive a screw through the wood and use this to hang things.
Check the small capsule of liquid along the center of the level.
Cleaning ensures that there is no oil dirt or moisture that could prevent adhesive glue from clinging to the wall.
This part will be easier if you have someone to hold the mount up for you.
Turn the screw to mushroom the slotted sleeve against the back wall surface.