How To Hang Letters On Wall Straight

Use a level to make sure your tape is perfectly straight.

How to hang letters on wall straight.

Use painters tape to mark center. Alternately a d ring can be used by attaching to the back of the letter with included hardware and tying the rope through the ring. Stick a piece of tape across the letters. Trim the letter layer close to the lettering at the top and along each side.

Then i eyeballed the blue tape where i wanted to be in the frame. For heavier letters grab double sided mounting tape. We re here to show how to hang wall letters with adhesive hardware and non marking hanging strips. I hung the frame on the wall so i could see where to place the blue tape.

Hold your letter up against the wall and adjust it until you think. Stick painters tape to the back of a long straight edge make sure it is very light weight. Hold your straight edge against the wall at the level that you want the bottom of your. Insert them into the letter just enough so it grabs the wood but doesn t go through the letter.

Lay the letters out on the floor. Attach two small screws to the back of the letter. Hanging wood letters on the wall. Most of our customers prefer hanging wood letters with hanging strips or double sided mounting tape.

Simply hang your art on the nail get it in position on the wall and tap the nail to mark the spot. You can also make a diy approximation by driving a nail through the bottom of a paint stir stick. Loop the end of the rope and tie to slide onto the head of the screw. Take your marked tape and place it on the wall where you want your pictures to hang.

Then use a screwdriver to make a hole where you want the nails to go. Using a tape measure find the center of the area that you want to hang your letters. Mark the spot where you want to hang the letter. Position the letter layer on the board.

Choose an adhesive based on the size and weight of the letters. You can see the full instructions here. For a frame with two brackets on the back place a piece of painters tape across the back. How you hang wall letters depends on the size weight and material of the lettering the mounting surface and if you can drill holes or not.

Cut paper strips the width of the side margins and apply them to the board with glue stick.