The first thing to check is what type of rail system your sliding closet door uses in order for it to slide.
How to fix sliding closet doors.
Loosen the screws at the top of both doors.
Push or pull the top of the closed door to align its edge parallel to the frame.
Step 4 tighten the overhead track.
A dirty obstructed or damaged track can make a sliding closet door jump off its track.
Open the door and then loosen the setscrew for the top bracket slightly with a screwdriver.
Step 5 replace.
Step 2 tighten screws.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
Loosen every single screw to ensure that you don t miss one and crack your.
Unlike entry doors sliding closet doors rarely have a bottom track.
Raise it just enough to clear the track and roll smoothly.
If your doors hang from a top rail and do not have a track on the floor then you need to either replace or tighten down the floor guides.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
Locate the two adjusting screws at the bottom of the door on the face or edge of the door and pry off the trim caps that cover the screws.
Open the door gently so the pivot doesn t slip then tighten the setscrew.
How to fix sliding closet doors.
To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.
See if the screws holding the guides down need tightening to be more secure.
Use an aerosol lubricant to lubricate all the door rollers.
Step 1 clean the track.
Then close it again.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
If the rollers are damaged install replacement rollers available at home centers.
To fix this issue first try.
When sliding closet doors are working properly they give you effortless access to your clothes shoes and furnishings.
To start your sliding glass door adjustment project first lift or lower the door on the track with a screwdriver or allen wrench.