How To Fix Roll Up Garage Door Spring

Hold the garage door and remove the vise grips from the track after the spring tension has been adjusted.

How to fix roll up garage door spring.

If there s an extra sheet then remove the curtain from the guides and roll the door all the way down to expose the broken spring. Spring replacement without removal of door assembly. Remove the cotter pin from the end of the axle pipe. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.

When the tracks of the roll up garage door come out alignment it can be a big and expensive fix to get the doors back in alignment so that the door will operate the way they re supposed to. Roll the door all the way down to expose the spring. Take the spring with you to the store so that you can choose the right size. Pull the cable as tight as possible before tightening the setscrews.

Unbolt the broken spring and remove it. This video applies t. Release your hold on the door and see if it stays up all the way. Ideally the door should slowly float up from this point.

Loosen set screw on spring s mark the spring with a welders chaulk or marker line from collar to collar flanges turn spring in direction of coil usually toward ceiling roof do not turn backwards as this will make sring climbe the collars. If you have gapped springs make sure that you take the compressed length and that you completely compress the spring when taking the 10 and 20 coil measurements. Rotate the drum to wind the cable into the winding grooves. Continue this process until the spring is loose and is not transferring its torque along the shaft to the pipe wrenches.

A gapped spring will allow a card or a dollar bill to slip between the coils without stretching the spring. Leave the locking pliers in place and repeat the tightening procedure on the other side. Clamp door with 2 c lamps vise grips tight on track over a roller to prevent door from lifting clamp regular vise grips to shaft after you turn shaft to make cables tight. Slowly close your door about halfway and release it.

Then attach the springs. All of the tracks will need to be pulled down shaped and either replaced or remounted from scratch to fit the wooden sides of the garage again. Loosen the silver pipe wrench and pull down on the orange pipe wrench to loosen the spring more.