The average cost for an oldsmobile silhouette power sliding door motor replacement is between 2 846 and 2 883.
How to fix power sliding door on 2002 oldsmobile silhouette.
Lift up or push down on the whole control to.
The power sliding door will only open if the transaxle is in park p.
If the sliding door on your van is hard to open and close or if it feels like the door of your van is stuck when you open and close it you can fix the stuc.
Estimate does not include taxes and fees.
This is draining my battery how can i fix this so it registers that the door is shut each door has on or two contacts that touch one or two other contacts when the door is closed.
I changed the fuse as it wasn t closing before.
Whenever the battery positive voltage supply to a rear side door actuator control module has been removed or the on board diagnostics have been activated the power sliding door system s must be re initialized.
Six way power seat the six way power seat control is located on the outboard side of the driver s front seat.
Both power sliding doors must be closed and in the latched position.
The power sliding side door on my oldsmobile 2002 silhouette keep opening and shutting continuously.
Pushing the bottom of the button turns the power sliding door off.
Labor costs are estimated between 141 and 178 while parts are priced at 2 705.
Move the front of the control up or down to adjust the front portion of the cushion up or down.
While holding the open close switch operate the on off switch through 10 on and off cycles within 10 seconds stopping in the on.
The rear side door actuator control modules monitor the power sliding door positions at all times.
Move the rear of the control up or down to adjust the rear portion of the cushion up or down.
Oldsmobile silhouette sliding door track and guides may become worn 10 reports.
Place the on off switch in he overhead console to the off position.
My1995 oldsmobile silhouette van sliding door is closed but the the power sliding door warning is always on.
Learn about this problem why it occurs and how to fix it.
I wire brushed the plate then it closed and opened fine.